#include <v17rx.h>
Public Attributes | |
int | bit_rate |
The bit rate of the modem. Valid values are 7200 9600, 12000 and 14400. | |
put_bit_func_t | put_bit |
The callback function used to put each bit received. | |
void * | put_bit_user_data |
A user specified opaque pointer passed to the put_but routine. | |
modem_rx_status_func_t | status_handler |
The callback function used to report modem status changes. | |
void * | status_user_data |
A user specified opaque pointer passed to the status function. | |
qam_report_handler_t | qam_report |
A callback function which may be enabled to report every symbol's constellation position. | |
void * | qam_user_data |
A user specified opaque pointer passed to the qam_report callback routine. | |
float | rrc_filter [V17_RX_FILTER_STEPS] |
The route raised cosine (RRC) pulse shaping filter buffer. | |
int | rrc_filter_step |
Current offset into the RRC pulse shaping filter buffer. | |
int | diff |
The state of the differential decoder. | |
unsigned int | scramble_reg |
The register for the data scrambler. | |
int | short_train |
TRUE if the short training sequence is to be used. | |
int | training_stage |
The section of the training data we are currently in. | |
int | training_count |
A count of how far through the current training step we are. | |
float | training_error |
A measure of how much mismatch there is between the real constellation, and the decoded symbol positions. | |
int16_t | last_sample |
The value of the last signal sample, using the a simple HPF for signal power estimation. | |
int | signal_present |
>0 if a signal above the minimum is present. It may or may not be a V.17 signal. | |
int | carrier_drop_pending |
Whether or not a carrier drop was detected and the signal delivery is pending. | |
int | low_samples |
A count of the current consecutive samples below the carrier off threshold. | |
int16_t | high_sample |
A highest magnitude sample seen. | |
uint32_t | carrier_phase |
The current phase of the carrier (i.e. the DDS parameter). | |
int32_t | carrier_phase_rate |
The update rate for the phase of the carrier (i.e. the DDS increment). | |
int32_t | carrier_phase_rate_save |
The carrier update rate saved for reuse when using short training. | |
float | carrier_track_p |
The proportional part of the carrier tracking filter. | |
float | carrier_track_i |
The integral part of the carrier tracking filter. | |
power_meter_t | power |
A power meter, to measure the HPF'ed signal power in the channel. | |
int32_t | carrier_on_power |
The power meter level at which carrier on is declared. | |
int32_t | carrier_off_power |
The power meter level at which carrier off is declared. | |
int | eq_step |
Current read offset into the equalizer buffer. | |
int | eq_put_step |
Current write offset into the equalizer buffer. | |
int | eq_skip |
Symbol counter to the next equalizer update. | |
int | baud_half |
The current half of the baud. | |
float | agc_scaling |
The scaling factor accessed by the AGC algorithm. | |
float | agc_scaling_save |
The previous value of agc_scaling, needed to reuse old training. | |
float | eq_delta |
The current delta factor for updating the equalizer coefficients. | |
complexf_t | eq_coeff [V17_EQUALIZER_PRE_LEN+1+V17_EQUALIZER_POST_LEN] |
The adaptive equalizer coefficients. | |
complexf_t | eq_coeff_save [V17_EQUALIZER_PRE_LEN+1+V17_EQUALIZER_POST_LEN] |
A saved set of adaptive equalizer coefficients for use after restarts. | |
complexf_t | eq_buf [V17_EQUALIZER_PRE_LEN+1+V17_EQUALIZER_POST_LEN] |
The equalizer signal buffer. | |
float | symbol_sync_low [2] |
float | symbol_sync_high [2] |
float | symbol_sync_dc_filter [2] |
float | baud_phase |
int | total_baud_timing_correction |
The total symbol timing correction since the carrier came up. This is only for performance analysis purposes. | |
int32_t | start_angles [2] |
Starting phase angles for the coarse carrier aquisition step. | |
int32_t | angles [16] |
History list of phase angles for the coarse carrier aquisition step. | |
const complexf_t * | constellation |
A pointer to the current constellation. | |
int | space_map |
A pointer to the current space map. There is a space map for each trellis state. | |
int | bits_per_symbol |
The number of bits in each symbol at the current bit rate. | |
int | trellis_ptr |
Current pointer to the trellis buffers. | |
int | full_path_to_past_state_locations [V17_TRELLIS_STORAGE_DEPTH][8] |
The trellis. | |
int | past_state_locations [V17_TRELLIS_STORAGE_DEPTH][8] |
The trellis. | |
float | distances [8] |
Euclidean distances (actually the squares of the distances) from the last states of the trellis. | |
logging_state_t | logging |
Error and flow logging control. |
float v17_rx_state_t::symbol_sync_low[2] |
Low band edge filter for symbol sync.
Referenced by v17_rx(), v17_rx_restart(), v32bis_restart(), and v32bis_rx().
float v17_rx_state_t::symbol_sync_high[2] |
High band edge filter for symbol sync.
Referenced by v17_rx(), v17_rx_restart(), v32bis_restart(), and v32bis_rx().
DC filter for symbol sync.
Referenced by v17_rx_restart(), and v32bis_restart().
Baud phase for symbol sync.
Referenced by v17_rx_restart(), and v32bis_restart().